Silly Spiral Mickey Coaster

This is a fun Mickey Mouse themed coaster to keep your drinks entertained, and to keep the condensation off your table. The spiral pattern allows ample room for condensation to fall off and stay inside the coaster.

Printing instructions

• For a dual-colour effect, apply a colour change after 3.0mm (verify in your slicer based on the layer height).
• The .gcode file I've included has a layer change in the right spot.

Assembly instructions

• I recommend adding some silicone dots underneath (see picture for suggested placement).

You can also check out my Circle Mickey Coaster.

Enjoy!

Update 2023-02-03:

• I've adjusted the spiral to make it a bit thicker and flow better with the border.
• There is now a 180 degree rotated spiral version. You can print a few of each and see if your guests notice!