20mm Radiator Hook

A simple hook which snaps on radiators with a thickness of 20mm.
This turns the radiator in an improvised coat rack, with the added benefit of drying and warming the coats.

The hook is designed to minimise sagging over time when printed in PLA.
Depending on how hot the radiator gets, a more heat resistant material like PETG might be beneficial.
Mind potential warping while printing, I have observed arcs slightly lifting in my PLA prints.

To attach the hook, firstly bend the tab backwards until you can slide it on without damaging the paint.
Then push down with your palm until it snaps into place.
Due to heat changing the properties of PLA, the hook might snap if attempting to remove it at a later time, if printed in this material.