Cable wraping tool

This tool is made to make wraping cables with center-split cable wrap (not spiral wrap) easier. Tested and working well on 16 mm I.D. cable wrap, but should work on other sizes too.

• You just mount the tool onto the cable gunch (put the cables inside the tool and twist the cetrel patr to close the gap)
• then you feed the cable wrap from the pointy end, until you can grap both cable ends
• and wrap end and then you hold both end pull towards you until the whole length of the cable bunch is wrapped.

The big part can be printed from whichever material you want, but the inner part should be printed out of PETG, since it needs to be sligtly deformed during assembly. Both parts need to be printed standing. Inner one standing on the knurled part, outer body standing so, that the pointy end is pointing upwards.

Category: Organization