Turntable Hinge for AT-LP120

I thickened the part the screw goes through, but I still had to shim the bottom or it floats too much. Thanks, good stop gap - I may order an actual replacement its not that expensive: https://www.audio-technica.com/en-us/svp-701-5500-5405 also are you this same dude: https://makerworld.com/en/models/1106807-audiotechnica-lp120-dust-cover-hinges?from=search#profileId-1102679

Hey! I know this is old now, but any chance you could extend the top part of the rectangle by about .75 inches? Haha

so far so good! Do you recall what size bolt this uses? thanks for sharing.

Thanks for this design. Without the spring-loaded nature of the AT original hinge, will this printed hinge hold the lid open (i.e., if you tighten the nut/bolt sufficiently)? Or do you always need to hold the lid with one hand and handle the record with the other?

Thank you for this! Making a gift for a friend that misplaced this one.