Prusa Mini screen usb mount

Hello there

I made this model for the Prusa Mini.

Because i was annoyed that i had to reach to the side for the usb stick.

So i sketched this up in a few minutes

i used this cable for the usb https://www.ebay.co.uk/itm/Left-right-Angle-USB-3-0-A-Male-to-Female-with-Screw-Panel-Mount-Extender-Cable/232278312253?ssPageName=STRK%3AMEBIDX%3AIT&var=531526255940&_trksid=p2060353.m2749.l2649

but i would Personally use this one instead just have not received it yet. https://www.aliexpress.com/item/32859381738.html?spm=a2g0s.9042311.0.0.3dd84c4d7WSVT5

The cable should be 30 cm that should be about right anymore is just to much and less then 20 then u cannot get the screen to stand 90 degrees

Feel free to ask questions and suggestion

Kind Regards Sebastian

Print instructions

I personally just used the stock prusa mini 0.2 profile with Prusament Petg Orange