Gopro backpack \ molle vest quick release mount

I was searching for a way to mount my “gopro” on my molle vest for airsoft.
So i made this design.
You will need:

4x 10 mm m3 screws and nuts.
1x velcro +/- 10 cm.
1x Gopro quick release buckle (i used one with a J hook)

I have made slot in the underplate where the velcro is resting.
This will be hold in place when screwing the bottom plate to the baseplate.

After that you can mount the camera to the base with the quick realse buckle.

I have printed everythin in 20% infill with a exception of the top part of the mainclip.
Within cura you can change the infil with a support blocker and then per model settings.
Or if you want to be completly sure print the top part 100% :-D