Laptop Stand

Laptop Stand designed for 15 inch Macbook Pro, but should work for many models.

• Six piece print
• Assembled with M3 threaded inserts, screws and washers.

Parts list

• 8x Initeq 3mm M3-0.5 Brass Threaded Metal Heat Set Screw Inserts (long version)
• 8x M3 x 16mm Button Head Cap Hex Screws
• 8x M3 Washers (7mm outer diameter)

The Initeq inserts are overall length 6.4mm with outer diameter at the top (wider end) is 5.6mm and, bottom is 4.85mm. Any inserts similar in size should work. Likewise, any M3x16mm or thereabouts should work as well. The washers aren't mandatory, but recommended.

Print instructions

Printed in PLA with 0.2mm layer height. Brims, lily pads and supports as needed.

Inserts were installed with Virtjoule Heat-Set Insert Installation tip for M3.