Glock Airsoft Magazine Lip

Printing Instructions

• Print without supports and at 100% infill.
• If using PrusaSlicer, I recommend disabling “Thick bridges” and enabling “Detect bridging perimeters”.

If you have assembly issues with the holes being too small, you can use a 2mm drill bit to drill out the holes before assembly.

Replacement Instructions

1. Make sure to empty all gas from the magazine before disassembly!
2. Remove the two metal pins holding the original part in place using a small pusher pin (e.g. a small nail or SIM Removal Tool) and a hammer.
3. Pull off the original part and remove the rubber seal.
4. Place the rubber seal in the newly printed part.
5. Place the replacement part back onto the magazine.
6. Carefully reinsert the metal rods using a hammer.