Small Cam Frame Enclosure Mount

I created this model to fit my small wide angle camera.  It has 2 female threaded holes 20mm apart  on center, and will accept m3 bolts to attach the cam.

This mount attaches to the frame tube of my Comgrow Enclosure.  The Tubing is 17mm but the mounting back plate and front plate has some wiggle room to go bigger or smaller by a few mm id say 14-20mm.  

I recommend supports on the curved faces only using prusa slicers paint on supports surface mode.  I also wanted the threads to be super secure so I created modifiers in my slicer to make the bolts and the female threads and also the connection to the go pro mount at 100% infill.  the rest of the model was at 15% infill

.2 layer height

I printed in pla 

15 infill (except the threaded areas)

After printing, i ran the bolts through the threads of the back plate working back and forth to clean up any residual strings or any blemishes that may have appeared.  The bolt threads were created with a slight tolerance so should work flawlessly after the initial cleaning just described.

Created in Fusion 360