Enclosure Frame Wyze Cam v3 Mount

I created this model to fit my Wyze Cam v3 which then attaches to the frame tube of my Comgrow Enclosure.  The Tubing is 17mm but the mounting back plate and front plate has some wiggle room to go bigger or smaller by a few mm id say 14-20mm.  

Wyze cam v3 is press fit from the front openning and very snug, there is also a small cable routing clip on one side

I recommend supports on the curved faces only using prusa slicers paint on supports surface mode.  I also wanted the threads to be super secure so I created modifiers in my slicer to make the bolts and the female threads at 100% infill.  the rest of the model was at 15% infill

.2 layer height

pla

15 infill (except the threaded areas)

After printing, i ran the bolts through the threads of the back plate working back and forth to clean up any residual strings.  they were created with a tolerance so should work flawlessly after the initial cleaning just described.

Created in Fusion 360