Super secure towel hook!

As the description says, I was tired of the hooks that were installed in my rental apartment. Luckily for me they were easily replace as the actual hooks are only secured with a M6 set screw on the part that is attached to the wall. So I designed this simple hook, where you thread the eyelet of the towel through the hole and then on the actual hook, this helps a lot with making sure that the towel doesn't fall off. I would've simply bought a new hook but I don't know which brand this is and have no idea if that sort of mount is some sort of standard or such.

If you want to use this hook but don't have the same mount for towels as I have, which I assume most people don't have, you can check out my other model which is my attempt at recreating the mount available soon!

The last two pictures are of the original hook and the mount.

Print settings

• Printer: Prusa MK3S
• Nozzle: Bondtech CHT 0.6 mm
• Layer height: Variable layer height 
• Perimeters: 3
• Infill pattern: Gyroid
• Infill density: 15 %
• Supports: Disabled
• Raft: Disabled
• Speed: 20 MVS
• Filament: Clas Ohlson PLA
• Nozzle temperature: 210 °C
• Bed temperature: 65 °C