Voron 2.4 Front Panel Handle, Hinge & Magnet Latch

Remix of the three models.
 

270° front panel hinged mounting method and magnet latch with M3 hinge axle for the Voron 2.4 (& others). Designed so it is not to interfer with the snap latch system.

https://github.com/VoronDesign/VoronUsers/tree/master/printer_mods/richardjm/snap-latch-2020

Front panel holes based on the original Voron 2.4 hole position, however this is to be checked.

BOM:

M3 x5x4mmØ brass heated inserts.

Handles - 8x M3x6mm SHCS. 4x 6x2mm magnets. 

Latches - 2x M3x6mm FHCS. 4x 6x2mm magnets.

Hinges - 8x M3x8mm FHCS for panel. 4x M3x16mm SHCS for hinge block, M3 washer recommended. 4x M3x45 SHCS hinge axles. 

9x3mm self adhesive foam tape. Installed on back face of door panel. Once installed check the compression locations and trim out the compressed foam for the door to close more flush to seal.