Ultraball Piggy Bank

The third design of the series! You can see my others here: Pokeball, Greatball, & Masterball

This is probably the harder one of the main 4 to print. The yellow insert does in fact fit perfectly in the slot of the top, you will just have to hold it in place while the glue sets and dries a little. 

As always, made to be printed without supports. I just strongly recommend printing the yellow insert at a snail pace for the first 6-7 mm with good bed adhesion.

If you'd like to help me out or have permission to sell physical items from my designs, please join my club!

Recommended print settings:

• 0.2mm layer height (0.16 for yellow insert)
• Slower speed for first 6-7mm for bottom and yellow insert pieces
• 3 perimeters
• 10% infill 
• NO SUPPORTS NEEDED but if you're struggling on the top/bottom it may help