EV Charging Pedestal Cap (6" square aluminum pipe cap)

I was unsatisfied with the generic hard rubber cap that came with my EV charging pedestal. 

I measured the nominal 6"x6"x0.25" material for exact measurements and created the model using Fusion360. 

Printed Settings:

When you slice this, you'll want to flip it over so the top face of the model is on the bottom, on the print surface. I used Prusa textured PEI.

• Prusament PETG Galaxy Black
• Prusa Mini+
• 0.20mm Quality
• 15% Infill, Gyroid
• Monotonic bottom layer (which is the top/outside of the printed cap)