Tailcap magnet Zebralight H602 Headlamp

I've created a neodymium magnet holder that fits in Zebralight's Tailcap, if tilcap measures 24.20mm in diameter this will work fine!

I did 2 versions, 1 to use with flex materials (the tailcap hole is narrower) 1 to use PLA etc, a little smaller than the tailcap measure.

Contact me if you want to use other magnets measurements; That I can change the design!

Hope you like it!

Remember that drawing uses a 15mmX5mm magnet. https://www.supermagnete.it/dischi-magneti-neodimio/disco-magnetico-diametro-15mm-altezza-5mm-neodimio-n42-nichelato_S-15-05-N

Stop printing and insert magnet inside!

Good printing!

Review for flashlight : http://en.lumenreviews.com/

Print Settings

Printer:

Prusa i3

Rafts:

Supports:

No

Resolution:

Infill:

20%

Notes: