Stella Athena Dresser/Bookcase Bracket

This is a bracket for the Stella Athena dresser and bookcase combo for those mounting the bookcase onto the dresser.  For some reason the hardware for this was not included so I made this in order to keep my daughter from eventually knocking the bookcase off the dresser and possibly getting hurt.

Recommended PETG with 4+ walls and same for top/bottom, and I printed the bracket on it's side, but I'd recommend DYOR on print orientations for strength.  Also, there are two black screws attached to the dresser at the top I used those as well as the short silver screw that came with the bag with the zip tie to prevent the tall furniture from tipping over. You'll need to pre-drill into the bookcase, and if you wish to use more than 2 of these you'll need to pre-drill both pieces.