This cup holder can be mounted to most flat surfaces using two M3 bolts.
24
79
0
756
updated September 8, 2023

Makes

Comments

Hi, I wanted to try this model out for my pool but the ring will be too small for the various types of "Yeti-style" cups that are used. You mentioned including the Fusion file, but I do not see them. Any chance you can post those files?

View one more comment

@enahs also, i am no fusion expert, so they may be built in a way that is difficult to edit. Might not be a problem for someone that knows the software better though.

@blueguell_350438 Thank you for following up on this. I'll definitely see what I can do. In the interim I modified another person's model and it's worked out great. However, I am more interested in your model being universal. When I get a chance to "create" something, I'll post it as a remix.

Printed great with no supports. Haven’t attached to ice house yet but intend to when winter hits again. Might even use it for the garage.
if you ever revisit this design, I think a way to attach this or the rod holder to a locator would be a great addition. Thanks!

@Gohmanopolis_480645 Thanks! I put this system to the test this winter and it worked well. i think for next season i am going to switch the male and female clips so that the male clip mounts to the sled and the female clip goes on the object. The problem i had this year was that the female part of the clip would fill with snow when pulling the sled to a new location. Not the end of the world, but kind of a pain to clean it out all the time if you move around a lot like i do.

All comments loaded