Anschütz magazinecap

Anschütz magazinecap for short magazines.

Print settings:

• .2mm Layer heigt
• .4mm Line width (for .4 mm nozzle)
• 2 Walls
• 3 Top layers
• 2 Bottom layers (14 Initial bottom layers if that setting exists to make the “hook thing” that hold on to the magazine itself stronger)
• Ironing can be enabled for a smoother top surface but not necessary
• 20% Infill (with those 14 bottom layers, otherwise I would recommend higer infill %)
• No support
• Coasting enabled 

If you use Cura I recommend using the “Enable Bridge Settings” in the experimental tab.

The model has some parts to help with adhesion that will need to be cut off after.

(Don't worry about the scuffed top on the blue one, I was impatient and had printed it with a raft)