Lego Differential that prints in 2 parts.
Nozzle: 0.25, 0.4mm are OK (printed both)
Layer Height: 0.1, 0.15mm are OK
v2:
1. The Gear now has deeper wells for the Arm to fit in. 2. Changes were made to make the part much stronger. 3. The inner gear locations and pegs are centered.
This print has two supports made in the model so that supports are not needed.
The Arm is inserted into the Gear wells. Using glue is highly advised.
Suggested Material: PETG
The author marked this model as their own original creation.
