AMS desiccant tray cover with tab
Added a tab to the back for easier lifting when it's installed in the AMS
33
211
9
1062
updated
January 20, 2023
Makes
Comments
Nice overall fit, and it is a lot easier to print than the last desiccant try I tried to make. I printed these in PETG with no problems.
My only real issue is that you definitely can't fit the original covers back on with these in there. I even tried cutting off the tab on one just to see if that was what was keeping the covers from fitting, but unfortunately it was just not happening. Still, hopefully that won't cause any issues in use, I'll have to them out more to verify but so far so good. (edited)
@ErinC_851391 For sure, these are meant to replace the original cover and packet, not be used with the original cover, sorry if that wasn't clear! In my experience, it's much easier to service these without the original cover there anyway as they can be easily lifted out, and you don't have to fiddle with releasing the clip. I can swap mine with just 1 spool removed from each side, and don't have to take both out like I did with the original setup.
@Worldspawn00 Thanks! That's good to know, and it helps to know you've had them that way with no issues. I admit I'm new to the AMS game, so I tend to be extra careful about my modifications.
Printed with PolyTerra PLA on AMS, and it was perfect.
Thanks for the files
Please add the bottom file as well for completeness. I accidentally printed the wrong one without holes. :)
@JonFairbanks No problem, added the file for bottom from the remix source.
@Worldspawn00 Everybody please don’t forget to like the remix source.
