Gridfinity LTT Screwdriver and bit holder

I wanted a holder where I could grab just the driver and bit set I wanted, so I came up with this! The main 1x6 driver holder can optionally hold two rows of bits around the shank of the driver, or you can use the 1x1 bit trays if that's more your style.

Misc. tips:

• Sanding the side of the 1x12 bit holders really brings out the contrast in the lettering
• This will fit on an Ender 3 if rotated 45 degrees and you remove any skirt. Watch out for bed clips!
• Bit holders are a pretty good fit but the 1x1 trays could be improved by adding a magnet. I've included step files if that sounds like your idea of a good time
   

Model Origin

This design was heavily remixed from this design. Ultimately I ended up re-creating everything myself, but I did use this design for general measurements and holder inspiration.