CR6SE Ultimate Direct Drive for microswiss extruder and hotend

UPDATE 15/01/2023

Added a stability clip to prevent movement, uses 2x m3 x 10mm screws with 2x m3 nuts (nuts on the inside) or alternatively superglue it to the printed shroud

printing settings

• PETG or ABS
• 40% infill
• TREE SUPPORTS!!
• ROTATE THE OBJECT SO THE HOTEND COVER IS FACING UP
• IF YOU HAVE ADHESION PROBLEMS USE A BRIM 

install guide

• remove stock cover, fans
• (optional) add a washer or two to the left hotend screw on the bed leveler piece so it doesn't go down, do it if you have trouble leveling 
• install the ultimate DD
• install the fan and the duct ( it wont fit if you pre install it on the DD
• install the motor and extruder with a bit of bowden between the extruder and hotend, tighten well the ptfe tube screws
• done!

you will need

• 40mm fan duct found at https://www.thingiverse.com/thing:4777287
• 4x 16mm m3 screws for the fan
• 2x 10mm m3 screws for the DD
• longer cable for extruder motor

extra

you can also install a 40mm hotend fan, i used the stock adapter with also a 40mm adapter, i used this https://www.thingiverse.com/thing:4667141

REMIXED FROM

https://www.thingiverse.com/thing:4777287 By onlydave

 https://www.thingiverse.com/thing:5217783 By Phoenixcustom