MasterChef Handheld Blender Bracket

WHAT IS IT

This is a wall mounted bracket for the MasterChef handheld blender. If you want to remove the blender from the bracket push it up slightly and pull it so the it comes out of the seat and reverse the process to reinsert it after you are done

PRINT

I printed this with the Creality Ender 3v2 at 90mm/s with initial layer speed set to 10 mm/s. 6 wall line count/1.2mm wall thickness. 20% Infill is enough for this print as the walls are thick enough to support the weight. 

I used no supports but if you want to reduce the wall line count I would suggest turning the print vertically and adding supports 

I used M4x16 chipboard screws and turned it through the plastic, but you can use strong double sided tape. 

My print warped due to a unlevel bed but it still worked as needed

YOU WILL NEED

A drill for the pilot hole if needed and a screwdriver 

OR

Strong double sided tape