This item is a mat that will hold up to 2 OEM Apple MagSafe pads on top of pad covering the POS wireless charger built into the Rivian R1T or R1S Center Console.
Installation is simple - insert the Apple MagSafe pad into the hole while aligning the plug in the right direction. Attach to the rubber pad via double sided tape. The pads will be kept in place by friction. It's recommended that you remove your phone from the charger at an angle to ensure they stay put.
Print in PETG or ABS top side down. A textured bed is recommended to get the same finish as shown in the picture. Supports were not needed for me and will likely not be for you as the overhangs are minimal.
This product is not available for sale on OpenSourceEV.com as the Ultimate pad kit was produced instead.
The author marked this model as their own original creation.