Trianglelab Filament Sensor Bowden Mount

Remix of this model by falo. (basically an entire re-design, but I used their model as a base) Their mount interfered with the mount I was using, so I figured other people may be interested. may be good for other mounts as well. Will allow you to use a real bowden coupler with a mount, rather than just floating inline.

Attach using an 20mm M3 bolt to your mount, holes are clearance. Included are an M10 and M6 coupler version, the M6 coupler will work best if you drill out the hole in the coupler to 4mm to make it passthrough. The short version will allow you to have a coupler on both sides of the sensor if you use two.

I suggest you attach it to your mount with the bolts, but don't tighten them all the way. The ptfe tube can insert through the coupler into the body of the sensor but you'll probably need to adjust the position. Once the tube is totally inserted, then fully tighten the screws.