Slaig

@Slaig

11l, 22l, 45l, 65l compatibility, f360 file available. Tip: print in half, It works really well and save a lot of time.

210

1303

4805

updated January 19, 2023

Befernafardofo

@Befernafardo_3524048

I had to glue them in place since they would fall off.
I feel like they don't press too much on the lid, but that's probably because they would be hard to close otherwise.
They make a satisfying snap when they close though!

hertzi

@hertzi

printed the 65l version in PLA - works very well

eBastlir

@eBastlir_6202

Works well, easy print with Prusament PETG. It could be more tight but nothing critical.

Slaig

@Slaig

Thanks for the feedback ! =)

Thanks.

Print in place hinge works great

Florin Popescu

@FlorinPopescu_895635

Works very well. I like that it can be glued to the boxes so they don't always fall around the room. I'd wish for a more efficient variant since with typical settings it takes 50-80 grams for 8 clips per each box. Sorry, cutting model in half results in a non-symmetric model which my "OCD" cannot accept.

Slaig

@Slaig

Thank you for your detailed feedback. Using less filament could be a good improvement, I will add this to the to do list ;)
By the way, I understand your disappointment, you can cut it on any junction, not in the middle, this way you will have a better looking model with less filament.

jimmylover

@jimmylover09_1793590

Nice model!
Printed 50% width and they work great

M 6

Mopf

@Mopf_2131832

It fits my box with gasket, and without. I love the block, as it holds the clip in place, even if I don't use glue or tape.
Nevertheless for closing it, I need a lot of force. And on the box without gasket it is pretty lose.

Samla 22L box ordered from IKEA online in Germany in July 2025
Used seal: Window Gasket 9x6mm D-profile (glued on the box, not on the lid)
Bambu Lab X1 Carbon
0.20mm Standard @BBL X1C with wall loops 3
eSUN PLA+