Nespresso Dispenser for Cabinet Door

Hi!

This is a heavily edited remix of the concept found in Mintax's original pod model here.  The idea here was to adapt the model to accommodate the Vertuo pod sizes as well as save as much space as possible as this is being mounted on the inside of a cabinet door in my kitchen.

Since the pods are larger and more difficult to contain in the dispenser, I also designed a “slider” add on which is glued to a 56mm x 66mm x 3mm piece of acrylic.  This provides a wall for the pods to remain in the dispenser, even when the cabinet door is swung open of slammed closed.  You just need to slide up the acrylic window (using the finger hole) grab your desired pod, then close it up again.

The completed dispenser was then attached to the door using 3M Command strips.

Hope you enjoy, and ad always I'm open to questions, comments and views on your makes!

Thanks,
Sean