Raspberry Pi Zero (v1.2) case

This is a quite minimal case for the Raspberry Pi Zero. Designed for the 1.2 version (the first version, before wifi and camera connector introduced). This will likely fit later Pi Zeroes, but the hole for the heatsink (over CPU) may not line up.

Designed this because I needed it for my portable case. I have previously had 2 other cases but I prefered to make one. The cheap chinese one I had was not really for purpose. I also previously had a Pimoroni Pibow case (specifically for v1.2 of Zero) whi worked, but you had to disassemble to get at SD card. In my version, the SD card sticks out the side so is easily got at!

Required Hardware…

• 4x M2.5 x 12mm bolts (I used 15mm in pic as it's what I had, but 12mm should be enough)
• 4x M2.5 nuts.