StreamDeck Conference Desk Center Module

I made this remake of my StreamDeck Faceplate by request to include some space for keystone modules. Printed at a fine detail to get the notches inside the space where the streamdeck sits to lock it properly. The face comes in two orientations. One where the Keystones are above the streamdeck, and one where they plug in from the bottom. Note that in the filename. 

A 0.4 nozzle is recommended to get the tolerance correct. I've tried it with 0,6 with a really tight fit which had some troubles. The whole unit is designed to fit inside a 127,5mm square space. The front face is 137,5mm across, so it covers the hole pretty nice. I printed it in PLA to have some flex in the plastic, as printing in a stiffer material would make removing the streamdeck a real pain. 

The angled frame is also made with the same dimensions, so one could chose to include that if an angle is desired. 

The Keystones have a tight tolerance, and the thinnest most layer of the front might snap once you pop it in the first time. But that's just a single strand of PLA, and it doesn't really effect the look.