Iris Keyboard Rev4 Mid Layer - 1.5mm plates, stand-off free - Integrated Supports

Iris Keyboard Rev4 Middle Layer.

I wanted a few changes to the cases on the Keebio Iris Case GitHub:

1) Does not require stand offs, screws thread directly into the layer.
2) Supports not required. I have adjusted overhangs to be beveled, and modeled in supports. See photos for support cross-section (also included is a support-free model).

Designed for 1.5mm plates.

Feedback welcome.

Print instructions

Tested and printed on Ender3 using Filastruder clear PETG, using a .4mm nozzle and .2mm layer height. My prints benefited from a brim to avoid lifting. Supports snap off cleanly. (See support cross-section)

Left hand models provided. (obviously mirror for right hand use).

See "No Supports" model if you want to have your slicer add supports directly.

Feedback welcome.