kd6102 case - "choppy"

This is a case for the "choppy" electronics kit available from jaycar:

https://www.jaycar.com.au/5a-12vdc-pwm-motor-speed-controller-kit/p/KD6102

The instructions over at https://diyodemag.com/projects/choppy_the_pwm_maker mention some 3D files but I couldn't find any so I made my own

Print instructions

Model prints fine with regular PLA and no support needed.

The PCB can be screwed or glued into the plastic standoffs inside the case. To prevent the cables being yanked out of the terminal blocks, make a cable tied loop or tie a knot in the leads to act as a strain relief. There is space at the end of the box for the loose cables.

The lid and knob should fit nicely into place and could also be glued if needed.

Because the potentiometer and cables are not restricted by the case, its easy to remove the board without having to rewire it