Swing Arm Mount Screen (or Tablet) Holder for - BiDirectional - Designed for Waveshare 7" Screen

A mounting solution for a tablet or other screen for the common 10mm microphone swingarm mount. Designed for the 7" Waveshare Universal Display Monitor.

The screen clip has a dovetailed connection on the rear, which allows the screen to be oriented vertically or horizontally.

Waveshare Display
Swingarm Example

Print instructions

Tested on an Ender3 using Filastruder PETG (clear). Sliced with CURA, printed at .2mm layer height. Print probably works with PLA, but the screen clip may wear out with time or heat. (I just happened to have PETG loaded up).

No supports needed, but a brim can be helpful if having issues with bed adhesion.

Note: the screen clip has one end of the dovetail sealed, be sure to orient that against the print bed.

Designed for the 7" Waveshare Universal Display Monitor. The screen clip has a dovetailed connection on the rear, which allows the screen to be oriented vertically or horizontally.

Waveshare 7" Display
Swingarm Example