Nerf Jolt REBORN!

The Nerf Jolt is one of my favorite blasters because of its compactness, cost, and reliability. One of the only things I don't like about it is it is not very accurate. This model allows you to simply clip a barrel onto the blaster and fire. The barrel folds back for loading purposes and the hinge is a single longer nerf screw.

ASSEMBLY AND OPERATION:

• first take your 2 3D printed parts and the screw and put the screw into the part with the T-MAN logo, put the barrel part's hinge between the two tabs on the T-MAN part.
  -Screw the screw in loosley, CAREFUL!!! you can break the 3D printed parts!!!!
  -Try rotating the barrel upward. If it doesn't swing try loosening the screw slightly.
  -Clip the assembled mass onto the top of the barrel of the jolt.
• make sure barrel is up. load dart
  -swing barrel down
  -And you are done!!! have fun with this mod!!!

If enough people use it I may publish the STL files so people with smaller printers can use this. also please let me know what you think in the comments

Print instructions

print this model with the .gcode included. please print in Prusa orange or very bright RED (or paint in one of these colors).