Prusa Mini - Nozzle Reminder V0.80

I keep forgetting which nozzle is in the printer.
That's why I created a reminder for my Prusa Mini. As soon as I change a nozzle, I set the reminder accordingly. It sits high up on the stepper motor of the z-axis, held by one or two magnets (optional).

This is the second version with nozzles 0.25, 0.40, 0.60 and 0.80mm. The first one was not designed for 0.80mm nozzles.

Printing information

Layer height: 0.20mm
Infill: Support cubic 20%
Support: none

Colour change - holder: 49,20 and 73,40mm
Colour change - selector: 8,20mm

Assembly

• Slide a piece of filament into the groove on the front of the holder. This is optional and only necessary for a perfect look. 
   
• Push a piece of filament into the hole provided in the selector. This is necessary for a good hold of the selector on the holder. This piece should be firmly attached to the selector. You can use some glue here if necessary.
   
• Stick a magnet (approx. 10mm diameter, 4mm height) into the hole at the bottom of the holder.
  I use two magnets on top of each other (each 2mm high). The holder then fits perfectly into the hole on the top of the stepper motor, stays in place, yet is easy to remove if necessary. 
  Alternatively, you can attach the holder to the stepper motor with double-sided adhesive tape. Use whatever you have available.

I am looking forward to your Makes! :-)

By the way: If you like the model, but you use other nozzles than the three I have provided, please write a comment. I will create an extended version if necessary.

The following filament was used in the pictures above:

• Extrudr PLA NX2 Black
  Extrudr PLA NX2 Neon Orange

If you like this model, feel free to check out my others here.

And maybe you would like to support me with a small donation. Feel free to use the support button on the top right of this page. I myself donate one or two Euros to each designer for an interesting model that is worth five stars to me.