Traxxas 4tec 2.0 Chassis Spoiler Mount

 *New Update just up-loaded: 01-22-2025 “File name labeled with UPDATE-v2.” See file for further update details.

 **New Update just up-loaded: 02-01-2023 “File name labeled with UPDATE.” See file for further update details.

***Had to brace the wing legs with two pieces of glue stick and tape to strengthen them during printing on original version, on the prusa printer.

 Made this 1/10 Traxxas 4tec 2.0 chassis mustang bodied car. It is a modular design that allows for different style of wings and tips. With that being said I have a few designs I am making for the ends and the wing itself. 

 It mounts almost 100% flush in factory location with 3 screws along with the small chassis enforcement bar. It does flex very well and can hold the weight of the car well, although I cannot promise the spoiler / wing legs will hold the full weight in a straight up and down because of the print position.

 The wing / spoiler is held on by one screw in each leg, the holes are 3mm x 0.50 thread pitch and 10mm deep in the design, hard to tell if the threads are actually there but should be perfect for all RC screws up-to 10mm in length.

Print Settings: Prusa

• PLA PRO -Inland
• Extrude Temp - 219c
• First Layer Hight - .32
• All other layers - .20
• Infill - 25%
• Concentric Top / Bottom Layers
• 85% speed on Prusa mks3

Print Settings: Creality K1 Max

• PLA PRO -Inland
• Extrude Temp - 230c
• Bed Temp - 50c
• All Layers - .20mm
• Infill - 50%
• Top Layer Pattern -Monotonic Line
• Bottom Layer Pattern - Monotonic