ClosetMaid "Wood" Shelf Label Holder

A print to hold a label on an Elfa or similar thickness shelf to help with organization. 

For shelves ~0.6 in or ~15 mm thick.

The model prints in two pieces (the clip and the label holder). Can either snap together and leave as is or add a little glue for a more permanent hold.  The shelf clip will work on shelves up to 5 mm thicker, but this will cause the clip to flex and the label holder to fall off, so best to glue together when using on shelves greater than 15 mm.

The flat part of the clip goes on the top of the shelf.

Can accommodate labels 2.3 in (58 mm) x 0.7 in (17 mm).

If using on shelves > 15 mm thick it is best to print the clip with PETG.