Dog Bowl Riser Scaled w/ Cylinder Core

I took SickDude's Dog Bowl Riser, shrunk the scale down a bit for my purpose and added a cylinder to the middle because the original had a strange gap in the center and wasn't symmetrical.

For scaling, unlink the proportions and adjust them individually as needed. I found it works quite well in Prusa/SuperSlicer to give it precise dimensions, just measure the bottom of your bowl and pad it out 10mm to 15mm depending on overall scale. Note that you will get weird results if the model is not square to the print surface in your slicer of choice. The smaller you shrink it, the thinner the overall structure gets so be advised if you want to turn it into a pizza box table 🤣.