X-Axis Cover for Aquila using Ender bracket

2023-01-09: Notes updated for M3x8 bolt.

My Aquila was missing the XE-bracket and the only replacement available was for the Ender 3.  Enders mount the cover using the same 4 screws as the stepper, whereas the Aquila cover uses two separate holes.

Instead of drilling and tapping the bracket, this mimics the shape of the Aquila cover but has cutouts to allow shorter M3x8 bolts instead of tapping 40-50mm through the plastic.

Recommend printing in provided orientation with supports.  The stubs for the switch might be messy, so pre-tap with the stock M3 screws before trying to mount the switch.

Tried printing upside down for a smooth face and less supports but the four motor mounts didn't print well.

Unfortunately the large area on the bottom of the bracket will clip the wheels so this reduces your total X range by 2-3cm.  Will create a new cover once I find a better bracket.

Note: I used 101.5% shrinkage compensation for PLA, adjust accordingly if dimensions slightly off.