Oral-B iO stand

Works great

Simple, prints fast, fits nicely and does its job :) Thanks fpr the model !

Much better than the last one I made!
Printed with Black PETG

Printed on 0.15 structural profile. I had a few strings with that settings, most probably the filament was a bit moist. I used PETG. Thanks for this amazing print. It fits really good and the stand is stable for the brushes. Good design. Nice print!

Great Design, thank you for sharing!

Printed in Prusament PLA pineapple yellow and extrudr PLA NX2 turquoise

I gotta tell you, printing that Oral-B iO stand was super easy! And the best part? It looks and works even better than I expected. I'm totally stoked about it! 😎

Works fine. Good design

Could you make one for IO 10? The charger is a little bigger, 67mm.