Skadis Holder for SIPA WZU 83 Key

A holder for a SIPA WZU 83 laundry machine key for the IKEA SKÅDIS pegboard.
4
9
0
296
updated August 2, 2023

Description

PDF

This is a SIPA WZU 83 laundry machine key holder for Ikea Skadis pegboards. It uses Skadis T-Nuts for easy and secure installation.

  • Insert key both ways
  • Slightly angled for easy access (space for fingers)
  • STEP files available for easy remixing
Read more about the Skadis T-Nuts Mounting System and check out the Skadis T-Nuts Collection for more Skadis accessories that use T-Nuts.

 

BOM

QtyDescriptionSourcing
1M2.5 DIN934 Hex NutAliexpress
1M2.5x12 (or longer up to 20mm) Socket Head Cap ScrewAliexpress

 

Printed Parts

QtyPart
1Skadis SIPA WZU 83 Mount
4Skadis T-Nut M2.5

 

Printing

Print the part in the original orientation. All STL files are pre-rotated for printing. Check out the Skadis T-Nuts page for T-Nut print settings.

Print Settings

  • Material: PETG, PLA, etc
  • Layer height: 0.2mm
  • Extrusion width: 0.4mm
  • Perimeters: 3 or more
  • Infill: 20% or more

 

Assembly and Installation

Step 1 - T-Nut

Prepare the T-Nut. Push the M2.5 hex nut into the bottom of the T-Nut. You may have to use some pliers or other tool to push them in.

Step 2 - Assembly

Push the M2.5 screw through the hexagonal access hole and through the screw hole. Screw the T-Nut onto the screw and leave a gap of about 2mm between the T-Nut and the holder.

Step 3 - Installation

Align the T-Nuts in the vertical orientation and push the assembly through the desired hole on the Skadis board. Tighten the M2.5 screw. The T-Nut will lock in the horizontal orientation on the back of the pegboard and hold the part tightly as you tighten the screw.

To remove the holder again just loosen the screw half a turn and pull the whole assembly off the board.

Tags



Model origin

The author remixed this model.

License