Bracket/stand for PARKSIDE PMGS 12 B2

The bracket allows horizontal mounting of the micro grinder to the desktop.

Print instructions

Recommended material: PETG, but PLA should also work
Settings: strongly advise to use more perimeters (4? 6?), 0.2mm layer height, supports required only for bracket.

You will need:

• Printed parts
• Mounting clamp from IKEA Tertial or similar (just L shaped bolt, jaw and nut, IKEA one has diameter of 7mm)
• One M4x50mm bolt (You may also use two M4x20, or M4x25) - hinge, two washers (for M4 bolts).
• Two M4x25 (M4x20 should also work)
• Optional: some padding (self-adhesive flece or rubber feet)

Holes in clamp (for hinge bolt) and in base (for mounting bolts) are tight enough to hold screws in place.