Parametrizable Slide-on Headphone Holder

Description

This is a quick headphone holder I designed in FreeCAD in about an hour or so, to hold my headphones on the side of my desk.

The design is parametrized, so you can change it to fit your headphones and desk.

Differences between v1 and v1.2 STLs:

• v1 has a slightly looser grip on the desk edge, and also has a slightly longer headphone holder piece.
• v1.2 is tweaked to fit both my desk, and my headphones better with a slightly tighter grip on the table, and a slightly shorter headphone holder piece.

If you're going to parametrize this to your own specifications, this doesn't matter, as this only applies to the STL files.

Specifications:

• Length: 81.7mm
• Width: 35mm
• Table grip length: 35mm
• Designed for a desk edge 16mm thick
• Headphone holder length: 41.2mm
• Time to print:
  • 2h 50m at 50% infill, 50mm/s
  • 1h 50m at 10% infill, 50mm/s

Of course all of these are variable, if you need to change them.

If you have any questions, or need any help, feel free to reach out!