I was inspired by rosdj's design on thingiverse, but wanted to create my own version with a filament change and no glue required. This is completely my own design. After finding a lot of people cheating with the meeple method, and the cards starting to show some wear the benefits of a 3D printed coin were welcome.
Print the FLAME side GREEN, pause halfway and then make the TENT side RED. Green means go, red means stop.
There is also a split version for a MMU. I do not own one, and I don't know for certain that I did it right, but the top half and bottom half are in their own files.
Don't forget to check out my Incan Gold Gem Boxes, and see my best inserts at my Etsy shop, Taylor Jane Design Co.
The author marked this model as their own original creation.