Pipe Clamp Phone Holder

I designed this phone holder so I could mount it to my monitor arm. The diameter of the pipe the holder mounts to, is 32mm. For the dimensions of the phone holder itself, look at the final image, which is a technical drawing with the most important dimensions.

The phone holder is printed in 4 parts, though you will need some extra hardware to put it together. In front of the technical drawing is an image that shows what specific hardware is required.

Support

If you'd like to support me for the 3D models I distribute for free, you can use the following AliExpress affiliate link: https://s.click.aliexpress.com/e/_AoUC8h

Whenever you buy something through this link, I get a small kickback without costs for you :)

Print Settings

Printer Brand: Anycubic

Printer: All-metal Mega

Rafts: No

Supports: Yes

Resolution: 0.1mm

Infill: 100%

Filament: ColorFabb PLA/PHA Standard Black

Notes:

You might want to take a look at the orientation of the midpiece, because too much support material can end up causing the print to look quite rough. The same goes for the phone holder part itself. If you add too much support material here, the side flaps holding the phone in place, might brake off when trying to remove the support material.