Razor Blade Scraper

This is a simple to print and lightweight razor blade scraper, which can be used
to release prints from your printbed, scrape paint of tiles, etc.

There are only two parts you need to print, with a combined print time of around 5 hours
(at 0.1mm layer height). Assembly requires a single M4 x 8mm bolt with M4 nut.

I would recommend printing both parts at 100% (though you might get away printing the blade holder with lower infill percentage), as that makes it a very sturdy non-flexing scraper.

Support

If you'd like to support me for the 3D models I distribute for free, you can use the following AliExpress affiliate link: https://s.click.aliexpress.com/e/_AoUC8h

Whenever you buy something through this link, I get a small kickback without costs for you :)

Print Settings

Printer Brand: Anycubic

Printer: All-metal Mega

Rafts: No

Supports: Yes

Resolution: 0.1mm

Infill: 100%

Filament: ColorFabb PLA/PHA Standard Black
Notes:

You might not need support for the chamfered overhangs, but just to be sure, I enabled them for this print.