RV Stabilizer Pad

8 inch Stabilizer pad for using on soft ground material, sand, dirt etc.

Print Settings

Printer:

Alfawise U20

Rafts:

No

Supports:

No

Resolution:

.15 layer height

Infill:

20% Cubic Subdivision

Filament:

Generic PLA

Black

Notes:

Printing now, will test when finished.

Post-Printing =============

Problems

I found this extremely difficult to remove from the print bed. Ended up having to bring it back up to temperature, pry all the way around with a thin but sturdy putty knife pushing the putty knife as far under the part as possible. By the way I use purple glue stick.

As slick as the PLA object is, I imagine it would be best if I were to adhere some kind of rubber/non-skid material to the upper surface to keep the stabilizer from slipping off of the pad.

Further testing as I get a chance.

Category: Other