SavageLau

@SavageLau

For checking z align after homing. Place between the bed and linear rod.

159

1712

6959

updated December 24, 2023

AtomicBleach

@AtomicBleach

Are you running the paper between the base and the print bed or the top of the alignment tool and the rod. After messing with it I think the one without the lip is easier to use since you need to carefully adjust without pressing the bed down.

Brianne

@Brianne_1384298

I can't believe I waited so long to print these. Works great!

greenman360

@greenman_676311

I printed this before I remembered that I have a Plus hotend on my standard SV06, which means the nozzle hit the bed before the lower rod hit this print. User error on that one, but to be fair I did just put the 'ol girl back in service after sitting for a while, thus the need to level in the first place.

But the print seems like it would work well, so I will rate with five stars. I ended up using a can of pepper instead, gantry level seems fine, lol.

Printed at .3 layer height with a .6 nozzle BEFORE leveling the gantry and it still turned out pretty clean considering all that. Great model!

Vectron

@Vectron_1043324

They work ok when by themselves, but with a macro for gantry leveling they are pretty helpful.

dmdouce

@dmdouce_1649672

Works good, and easy to store in my tool kit so always easy to find

Nick Husby

@NickHusby_1003141

Works well on my SV06. Printed in eSun ABS+. (edited)

Printed great, but unfortunately just a little too short for my SV07 plus.
I’m going to try and print a remix of these and see if those work better for me.

Dieter Weiler

@DieterWeiler_558574

@DittiDoes_495066 whats your problem, you can scale it

DittiDoes

@DittiDoes_495066

@DieterWeiler_558574 true it could be scaled but the sv07 plus has a different setup so the flat top of the remix I used actually works better out of the box. I’m sure this is perfect for the sv06 :)