RepRack Shelf Stand Leg Extension

This is leg extension for the RepRack: Spool Holder to elevate it off an existing shelf. I designed it to elevate the holder above an offset row of filament below it.

The foot extension has holes for screws to connect to the RepRack holder. I also needed to use the RodClamp parts to keep my stands from tipping and breaking (pictured). For my length, just over 6 ft (2 m), I should probably use 4 brackets but I've been gentle with the shelf and the three in my photo have been holding up for me.

To assemble, I used #6 x ¾" screws. Two on the Leg Extension to connect it to the RepRack bracket and two more, one from each side, to connect the RodClamps. I also used a couple from the front and back of the RepRack to hold them from sliding left and right on the EMT conduit.