Screwdriver holder for IKEA Skadis board

I was aiming for as compact model as possible, thus the walls of “funnels” holding screwdrivers are only 1mm thin and spaces between screwdrivers are just big enough so those fit and are nice to take out. Inspired by thipilopo's file holder, however designed from scratch.

Easy to print, only supports were needed for hooks (potentially could cut those down by moving them lower in model). As this is a ±7 gram model, I could not be bothered.

Hooks have small tolerances. Would not recommend not to have them as the hooks like to break when inserted into new Skadis board.