NodeMCU Case

A case for housing a NodeMCU (ESP8266) board with enough room for cable management. I added holes on both sides to get your sensor cables out of the case, if needed.

The case is also high enough to house all of your cable mess.

Walls are ~2mm thick so it shouldn't be a problem to add your logo or something like that in your slicer.

I'm using the case with NodeMCUs and attached sensors for my Home Assistant installation - managed via ESPHome.

Print instructions

• Supports: I'm printing without supports and got no issues.
• I like to enable ironing on all top surfaces, but maybe that's just a personal preference.